UV sterilization light for room

Thu, 04 Jun 2026 06:46:00 +0800

On an Anatol flash-drying line, downtime isn’t just idle time—it’s substrate going in the trash and due dates slipping. Retrofitting a UV lamp usually means wrestling with cabinet wiring, re-flashing controllers, or crossing your fingers the ballast doesn’t blow. We built a drop-in replacement for Anatol flash systems that gives you more output without touching the existing electrical path.

What matters, technically

The lamp is built around a high-purity quartz sleeve and an ozone-free, medium-pressure mercury vapor arc. Spectral output peaks at 365nm, which is what gets photoinitiators excited in most UV inks and coatings. Peak irradiance hits 1200 mW/cm² at the focal plane, putting curing energy density at 800–1200 mJ/cm² in a single pass. The reflector uses a dichroic coating tuned to 365nm, so usable UV comes out about 25% higher than you’d get from a standard aluminum reflector. Input power is matched to the original Anatol socket: 1200W at 110V or 2400W at 220V. It uses a standard two-pin quartz connector and the same arc length, so lamp position repeats without re-alignment. Start-up is instant—no preheat—and lamp life is rated to 2000 hours with less than 5% output decay.

Room on UV Curing Direct

UV sterilization light for room

What matters, technically